Dyson DC07 Hose removal
Remember to have the appliance unplugged before attempting this repair.
Tools needed:
None
Possible symptoms
The back suction hose can become ripped and may need replacing at some point.
The connector can also pull away from the hose as on the dyson vacuum it is only glued in and not threaded onto the hose.
The hose can get blocked and removing to allows a brush handle to be pushed into it and hopefully unblocking it.
Where to buy a replacement hose
If you need to buy a replacement hose please click Here
First job is unclip the mains cable
Unclip the wand latch and pull the wand out of the hose as far as it will go
The wand is fully extended and needs to be unlocked from the hose. Press the unlock button on the hose cuff and remove wand
Remove the wand
The hose is secured at the bottom of the dyson with this button here (arrowed)
Simultaneously press the button and pull the hose lower cuff up (behind the button)
As you pull the lower cuff it will slide up
Hose is removed for replacement ,unblocking etc
When refitting hose ensure the locating lug on the lower cuff is correctly aligned
Please remember to PAT test your appliance after repair and if in any doubt get a professional to do it.
If you have any comments on this guide please email me